Here we can see “Autodata 3.38 Runtime Error 217”
Autodata 3.38 runtime error 217 at 004BB10D
I set up automatic 3.38 on windows, but I had been told I needed to place upgraded for visual c + 2010. When I began to run the app, I get this Error of rounding 217 in 004BB10D
Method 1: I advise you to perform the blank boot and assess.
The Way to troubleshoot an issue by doing a clean boot in Windows Vista or Windows 7
http://support.Microsoft.com/kb/929135
Note: Once troubleshooting, make sure you configure the pc to begin as usual, as cited in step 7 in the article mentioned above.
Method 2: as an alternative, you can finish the restoration of this System on your PC.
System Restore will require your personal computer condition permeable when it didn’t face this kind of issue. This may be achieved by choosing the correct restore stage.
To restore the operating system to a previous point in time, follow these steps:
A. click Start, kind System Restore from the search box, and click the System restore from your software list.
If you’re prompted for an administrator password or an affirmation, sort your password click continue.
B. from the System Restore dialogue box, click Choose a different restore point and then click Next.
C. from the record of restore points, click a restore point made until you started with the issue, then click Next.
D. click End.
If the given methods are worked for You, Comment below.
